Set Spantree Protomigration; Show Spantree Portstate - Enterasys Matrix DFE-Gold Series Configuration Manual

set spantree protomigration

set spantree protomigration
Use this command to reset the protocol state migration machine for one or more Spanning Tree
ports. When operating in RSTP mode, this forces a port to transmit MSTP BPDUs.
Syntax
set spantree protomigration port-string true
Parameters
port‐string
true
Defaults
None.
Mode
Switch command, Read‐Write.
Example
This example shows how to reset the protocol state migration machine on fe.1.12:
Matrix(rw)->set spantree protomigration fe.1.12 true

show spantree portstate

Use this command to display the state (blocking, forwarding, etc.) for a port on one or more
Spanning Trees.
Syntax
show spantree portstate [port port-string] [sid sid]
Parameters
port port‐string
sid sid
Defaults
• If port‐string is not specified, current state will be displayed for all Spanning Tree ports.
• If sid is not specified, current port state will be displayed for Spanning Tree 0.
Mode
Switch command, Read‐Only.
Specifies the port(s) for which protocol migration mode will be enabled.
For a detailed description of possible port‐string values, refer to "Port
String Syntax Used in the CLI" on page 4‐2.
Enables protocol migration mode.
(Optional) Displays the Spanning Tree state for specific Spanning Tree
port(s). For a detailed description of possible port‐string values, refer to
"Port String Syntax Used in the CLI" on page 4‐2.
(Optional) Displays the state for a specific Spanning Tree identifier.
Valid values are 0 ‐ 4094. If not specified, SID 0 is assumed.
Enterasys Matrix DFE-Gold Series Configuration Guide 6-53
Configuring Spanning Tree Port Parameters