Set Port Lacp - Enterasys Matrix DFE-Gold Series Configuration Manual

Configuring LACP
Matrix(rw)->show port lacp port fe.1.12 status summary
Port
fe.1.12
This example shows how to display LACP counters for port fe.1.12:
Matrix(rw)->show port lacp port fe.1.12 counters
Port Instance:
LACPDUsRx:
LACPDUsTx:
IllegalRx:
UnknownRx:
ActorSyncTransitionCount:
ActorChangeCount:
ActorChurnCount:
ActorChurnState:
MuxState:
MuxReason:

set port lacp

Use this command to set link aggregation parameters for one or more ports.
Syntax
set port lacp port port-string {[aadminkey aadminkey] [aportpri aportpri] [asyspri
asyspri] [aadminstate {lacpactive | lacptimeout | lacpagg | lacpsync | lacpcollect
| lacpdist | lacpdef | lacpexpire}] [padminsyspri padminsyspri] [padminsysid
padminsysid] [padminkey padminkey] [padminportpri padminportpri] [padminport
padminport] [padminstate {lacpactive | lacptimeout | lacpagg | lacpsync |
lacpcollect | lacpdist | lacpdef | lacpexpire}] [enable | [disable]}
Parameters
port port‐string
aadminkey aadminkey
aportpri aportpri
asyspri asyspri
4-66 Port Configuration
AggrActor System Partner System
Pri: System ID:
none [(32768,00e0639db587,32768),(32768,000000000000, 1411)]
ChurnMonitor
detached
Specifies the physical port(s) on which to configure LACP. For a
detailed description of possible port‐string values, refer to "Port String
Syntax Used in the CLI" on page 4‐2.
Sets the port's actor admin key. LACP will use this value to form an
oper key and will determine which underlying physical ports are
capable of aggregating by comparing oper keys. Aggregator ports allow
only underlying ports with oper keys matching theirs to join their LAG.
Valid values are 1 ‐ 65535.
Sets the port's actor port priority. Valid values are 0 ‐ 65535, with lower
values designating higher priority.
Sets the port's actor system priority. The LACP implementation on the
Matrix Series device uses this value to determine aggregation
precedence when there are two devices competing for the same
aggregator. Valid values are 0 ‐ 65535, with higher precedence given to
lower values.
Note: Only one LACP system priority can be set on a Matrix Series device,
using either this command, or the set lacp asyspri command
on page 4-60).
Key: Pri: System ID:
fe.1.12
0 MarkerPDUsRX:
0 MarkerPDUsTx:
0 MarkerResponsePDUsRx:
0 MarkerResponsePDUsTx:
0 PartnerSyncTransitionCount:
1 PartnerChangeCount:
0 PartnerChurnCount:
PartnerChurnState:
BEGIN = TRUE
set port lacp
Key:
0
0
0
0
0
0
0
ChurnMonitor
("set lacp asyspri"