Show Cep Port; Set Cep - Enterasys Matrix DFE-Gold Series Configuration Manual

Configuring Convergence End Points (CEP) Phone Detection
Examples
This example shows how to display CEP policy information:
Matrix>show cep policy
CEP default policies
CEP Type
--------
cisco
siemens
h323
sip

show cep port

Use this command to display enable status of all supported CEP types.
Syntax
show cep port port-string
Parameters
port‐string
Defaults
None
Mode
Read‐Only.
Examples
This example shows how to display CEP status information for port fe.1.21:
Matrix>show cep port fe.1.21
Port
----------
fe.1.21

set cep

Use this command to globally enable or disable CEP detection.
Syntax
set cep {enable | disable}
Parameters
enable | disable
25-42 Authentication Configuration
Policy Index Policy Name
------------ ------------
13 Cisco IP Phone
9 IP Phone Siemens
3 IP Phone Avaya
0
Displays CEP status for one or more ports. For a detailed description of
possible port‐string values, refer to "Port String Syntax Used in the CLI"
on page 4‐2.
H323 Siemens
-------- --------
enabled enabled
Globally enables or disables CEP detection.
Cisco SIP
-------- --------
enabled disabled
show cep port