Set Lacp; Show Lacp Output Details - Enterasys Matrix DFE-Gold Series Configuration Manual

set lacp

System Identifier:
System Priority:
Attached Ports:
Table 4‐9 provides an explanation of the command output.
Table 4-9 show lacp Output Details
Output...
Aggregator
Actor
Partner
System Identifier
System Priority
Admin Key
Oper Key
Attached Ports
set lacp
Use this command to disable or enable the Link Aggregation Control Protocol (LACP) on the
device. LACP is enabled by default.
Syntax
set lacp {disable | enable}
Parameters
disable | enable
Defaults
None.
Actor
00:e0:63:9d:b5:87
Admin Key:
Oper Key:
None.
Disables or enables LACP.
00:00:00:00:00:00
32768
32768
32768
What it displays...
LAG port designation. Each Matrix Series module provides
link aggregator ports, which are designated in the CLI as lag.0.1
4
through lag.0. . Once underlying physical ports (i.e.; fe.x.x, ge.x.x)
are associated with an aggregator port, the resulting Link Aggregation
Group (LAG) is represented with a lag.x.x port designation.
Local device participating in LACP negotiation.
Remote device participating in LACP negotiation.
MAC addresses for actor and partner.
System priority value which determines aggregation precedence. Only
one LACP system priority can be set on a Matrix Series device, using
either the set lacp asyspri command
page 4-60), or the set port lacp command
.
page 4-66)
Port's administratively assigned key.
Port's operational key, derived from the admin key. Only underlying
physical ports with oper keys matching the aggregator's will be allowed
to aggregate.
Underlying physical ports associated with this aggregator.
DFE-Gold Series devices allow for up to four ports per
aggregator.
Enterasys Matrix DFE-Gold Series Configuration Guide 4-59
Partner
32768
32768
("set lacp asyspri" on
("set port lacp" on
Configuring LACP
4
virtual
Matrix