Show Ip Route - Enterasys Matrix DFE-Gold Series Configuration Manual

show ip route

Defaults
None.
Mode
Switch command, Read‐Write.
Usage
The Enterasys Matrix Series device uses BOOTP/DHCP to obtain an IP address if one hasn't been
configured. RAD can also be used to retrieve a text configuration file from the network.
In order for RAD to retrieve a text configuration file, the file must be specified in the BootP tab.
RAD on DFE devices will only accept an address from a DHCP or BootP server if the lease time for
the address is set to infinity (unlimited). This will prevent the DFE from switching addresses when
a lease time expires.
Example
This example shows how to disable RAD:
Matrix(rw)->set rad disable
show ip route
Use this command to display the switch's IP routing table entries.
Syntax
show ip route
Parameters
None.
Defaults
None.
Mode
Switch command, Read‐Only.
Example
This example shows how to display the IP routing table:
Matrix(rw)->show ip route
ROUTE TABLE
Destination
------------------------------------------------------------------------------
default
10.0.0.0
127.0.0.1
Table 12‐2 provides an explanation of the command output.
Gateway Mask
12.22.73.13 00000000
12.22.73.13 ff000000
127.0.0.1 00000000
Managing Switch Network Addresses and Routes
TOS Flags Refcnt Use
0 UC 0
0 UC
0 UH 0
Enterasys Matrix DFE-Gold Series Configuration Guide 12-5
Interface
0 host0
0 host0
104 lo0