Show Snmp Notifyprofile - Enterasys Matrix DFE-Gold Series Configuration Manual

Configuring SNMP Notification Parameters
Defaults
None.
Mode
Switch command, Read‐Write.
Example
This example shows how to delete the SNMP notify filter "pilot1":
Matrix(rw)->clear snmp notifyfilter pilot1 subtree 1.3.6

show snmp notifyprofile

Use this command to display SNMP notify profile information. This associates target parameters
to an SNMP notify filter to determine who should not receive SNMP notifications.
Syntax
show snmp notifyprofile [profile] [targetparam targetparam] [volatile |
nonvolatile | read-only]
Parameters
profile
targetparam
targetparam
volatile | nonvolatile
| read‐only
Defaults
If no parameters are specified, all notify profile information will be displayed.
Mode
Switch command, Read‐Only.
Example
This example shows how to display SNMP notify information for the profile named "area51":
Matrix(rw)->show snmp notifyprofile area51
--- SNMP notifyProfile information ---
Notify Profile
TargetParam
Storage type
Row status
5-38 SNMP Configuration
(Optional) Displays a specific notify profile.
(Optional) Displays entries for a specific target parameter.
(Optional) Displays notify filter entries of a specific storage type.
= area51
= v3ExampleParams
= nonVolatile
= active
show snmp notifyprofile