No Ip Irdp Multicast; Show Ip Irdp - Enterasys Matrix DFE-Gold Series Configuration Manual

no ip irdp multicast

Mode
Router command, Interface configuration: Matrix>Router(config‐if(Vlan 1))#
Usage
The "no" form of this command clears an IP address from being advertised.
Example
This example shows how to advertise IP address 183.255.0.162 with a preference of 1 on VLAN 1:
Matrix>Router(config)#interface vlan 1
Matrix>Router(config-if(Vlan 1))#ip irdp address 183.255.0.162 1
no ip irdp multicast
Use this command to enable the router to send IRDP advertisements using broadcast rather than
multicast transmissions. By default, the router sends IRDP advertisements via multicast.
Syntax
no ip irdp multicast
Parameters
None.
Defaults
None.
Mode
Router command, Interface configuration: Matrix>Router(config‐if(Vlan 1))#
Example
This example shows how to enable the router to send IRDP advertisements using broadcast:
Matrix>Router(config)#interface vlan 1
Matrix>Router(config-if(Vlan 1))#no ip irdp multicast

show ip irdp

Use this command to display IRDP information.
Syntax
show ip irdp [vlan vlan-id]
Parameters
vlan vlan‐id (Optional) Displays IRDP information for a specific VLAN. This VLAN
must be configured for IP routing as described in "Pre‐Routing
Configuration Tasks" on page 2‐100.
Enterasys Matrix DFE-Gold Series Configuration Guide 21-59
Configuring IRDP