Clear Lacp Static; Show Lacp Singleportlag - Enterasys Matrix DFE-Gold Series Configuration Manual

clear lacp static

Example
This example shows how to add port fe.1.6 to the LAG of aggregator port 4:
Matrix(rw)->set lacp static lag.0.484 fe.1.6
clear lacp static
Use this command to remove specific ports from a Link Aggregation Group.
Syntax
clear lacp static lagportstring port-string
Parameters
lagportstring
port‐string
Defaults
None.
Mode
Switch command, Read‐Write.
Example
This example shows how to remove Fast Ethernet port 6 in module 1 from the LAG of aggregator
port 4:
Matrix(rw)->clear lacp static lag.0.484 fe.1.6

show lacp singleportlag

Use this command to display the status of the single port LAG function.
Syntax
show lacp singleportlag
Parameters
None.
Defaults
None.
Mode
Switch command, Read‐Only.
Specifies the LAG aggregator port from which ports will be removed.
Specifies the port(s) to remove from the LAG. For a detailed description
of possible port‐string values, refer to "Port String Syntax Used in the
CLI" on page 4‐2.
Enterasys Matrix DFE-Gold Series Configuration Guide 4-63
Configuring LACP