Clear Spantree Lptrapenable; Set Spantree Disputedbpduthreshold - Enterasys Matrix DFE-Gold Series Configuration Manual

clear spantree lptrapenable

Example
This example shows how to display the current Loop Protect event notification status:
Matrix(rw)->show spantree lptrapenable
LoopProtect event traps are enabled
clear spantree lptrapenable
Use this command to return the Loop Protect event notification state to its default state of
disabled.
Syntax
clear spantree lptrapenable
Parameters
None.
Defaults
None.
Mode
Switch command, Read‐Write.
Example
This example shows how to reset the Loop Protect event notification state to the default of
disabled
Matrix(rw)->clear spantree lptrapenable

set spantree disputedbpduthreshold

Use this command to set the disputed BPDU threshold, which is the number of disputed BPDUs
that must be received on a given port/SID until a disputed BPDU trap is sent.
Syntax
set spantree disputedbpduthreshold value
Parameters
value
Defaults
None.
Mode
Switch command, Read‐Write.
Specifies the number of disputed BPDUs that must be received on a
given port/SID to cause a disputed BPDU trap to be sent.
A threshold of 0 indicates that traps should not be sent. The default
value is 0.
Enterasys Matrix DFE-Gold Series Configuration Guide 6-75
Configuring Spanning Tree Loop Protect Features