Set Linkflap Interval; Set Linkflap Action - Enterasys Matrix DFE-Gold Series Configuration Manual

Configuring Link Traps and Link Flap Detection

set linkflap interval

Use this command to set the time interval (in seconds) for accumulating link down transitions.
Syntax
set linkflap interval port-string interval_value
Parameters
port‐string
interval_value
Defaults
None.
Mode
Switch command, Read‐Write.
Examples
This example shows how to set the link flap interval on port fe.1.4 to 1000 seconds:
Matrix(rw)->set linkflap interval fe.1.4 1000

set linkflap action

Use this command to set reactions to a link flap violation.
Syntax
set linkflap action port-string {disableInterface | gensyslogentry | gentrap |
all}
Parameters
port‐string
disableInterface |
gensyslogentry |
gentrap | all
Defaults
None.
4-44 Port Configuration
Specifies the port(s) on which to set the link flap interval. For a detailed
description of possible port‐string values, refer to "Port String Syntax
Used in the CLI" on page 4‐2.
Specifies an interval in seconds. A value of 0 will set the interval to
forever.
Specifies the port(s) on which to set the link flap action. For a detailed
description of possible port‐string values, refer to "Port String Syntax
Used in the CLI" on page 4‐2.
Sets the reaction as:
• Disabling the interface
• Generating a Syslog entry
• Generating an SNMP trap message, or
• All of the above.
set linkflap interval