Show Ip Pimsm Rp; Show Ip Pimsm Neighbor Output Details - Enterasys SecureStack C2 C2G170-24 Configuration Manual

show ip pimsm rp

Parameters
vlan‐id
Mode
Any router mode.
Defaults
If the VLAN id is omitted, all neighbors off all interfaces will be displayed.
Example
This example shows how to display PIM information:
C2(su)->router> show ip pimsm neighbor
Vlan ID
---------
30
6
Table 20‐11 provides an explanation of the command output.
Table 20-11 show ip pimsm neighbor Output Details
Output Field
Vlan ID
IP Address
Up Time
Expiry Time
show ip pimsm rp
This command displays the PIM information for candidate Rendezvous Points (RPs) for all IP
multicast groups or for a specific group address. The information in the table is displayed for each
IP multicast group.
Syntax
show ip pimsm rp {group-address group-mask | all | candidate}
Parameters
group‐address
group‐mask
all
candidate
20-56 IPv4 Routing Protocol Configuration
(Optional) Display all neighbors discovered on a specific Interface.
NEIGHBOR TABLE
IP Address Up Time
(hh:mm:ss)
---------------- ----------
192.168.30.2 01:36:41
192.168.6.1 01:36:41
What it displays
VLAN id of the interface.
The IP Address of the neighbor on an interface
The time since this neighbor has become active on this interface.
The expiry time of the neighbor on this interface.
The multicast group IP address.
The multicast group address subnet mask.
For all known group addresses.
Display PIM‐SM candidate‐RP table information.
Expiry Time
(hh:mm:ss)
------------
00:01:25
00:01:25