Set Vlan Interface; Show Vlan Interface Output Details - Enterasys Matrix DFE-Gold Series Configuration Manual

Assigning Port VLAN IDs (PVIDs) and Ingress Filtering
Mode
Switch command, Read‐Only.
Example
This example shows how to display the interface entry for VLAN 1:
Matrix(rw)->show vlan interface 1
VLAN
-------------------------------------
1
Table 7‐3 provides an explanation of the command output.
Table 7-3 show vlan interface Output Details
Output...
VLAN
Port
Storage Type

set vlan interface

Use this command to create, disable or enables a MIB‐II interface mapped to a VLAN.
Syntax
set vlan interface vlan-list {create | disable | enable} [volatile]
Parameters
vlan‐list
create | disable |
enable
volatile
Defaults
If volatile is not specified, entries will be created as nonvolatile.
Mode
Switch command, Read‐Write.
Example
This example shows how to create a volatile interface entry mapped to VLAN 1:
Matrix(rw)->set vlan interface 1 volatile
7-12 802.1Q VLAN Configuration
Port Storage Type
vlan.0.1 non-volatile
What it displays...
VLAN ID.
Port-string designation.
Whether the entry is stored as a volatile or non-volatile entry. Volatile
entries are lost when a system is reset. Non-volatile entries are saved
in NVRAM and are persistent until cleared.
Specifies the VLAN(s) for which an interface entry will be created,
disabled or enabled.
Creates, disables or enables an interface entry.
(Optional) When the create keyword is used, stores the entry as a
volatile entry. Volatile entries are lost when a system is reset. Non‐
volatile entries are saved in NVRAM and are persistent until cleared.
set vlan interface