Show Spantree Adminedge; Set Spantree Adminedge - Enterasys Matrix DFE-Gold Series Configuration Manual

Configuring Spanning Tree Port Parameters
Example
This example shows how to reset the admin path cost to 0 for fe.3.2 on SID 1:
Matrix(rw)->clear spantree adminpathcost fe.3.2 sid 1

show spantree adminedge

Use this command to display the edge port administrative status for a port.
Syntax
show spantree adminedge [port port-string]
Parameters
port‐string
Defaults
If port‐string is not specified edge port administrative status will be displayed for all Spanning Tree
ports.
Mode
Switch command, Read‐Only.
Example
This example shows how to display the edge port status for fe.3.2:
Matrix(rw)->show spantree adminedge port fe.3.2
Port fe.3.2 has a Port Admin Edge of Edge-Port

set spantree adminedge

Use this command to set the edge port administrative status on a Spanning Tree port.
Syntax
set spantree adminedge port-string {true | false}
Parameters
port‐string
true | false
Defaults
None.
6-60 Spanning Tree Configuration
(Optional) Displays edge port administrative status for specific port(s).
For a detailed description of possible port‐string values, refer to "Port
String Syntax Used in the CLI" on page 4‐2.
Specifies the edge port. For a detailed description of possible port‐string
values, refer to "Port String Syntax Used in the CLI" on page 4‐2.
Enables (true) or disables (false) the specified port as a Spanning Tree
edge port.
show spantree adminedge