Show Reset; Resetting The Device; Purpose; Commands - Enterasys Matrix DFE-Gold Series Configuration Manual

Resetting the Device

Resetting the Device

Purpose

To reset one or more device modules, to clear the user‐defined switch and router configuration
parameters, or to schedule a system reset in order to load a new boot image.

Commands

The commands used to reset the device and clear the configuration are listed below and described
in the associated sections as shown.
For information about...

show reset

reset
reset at
reset in
clear config
show reset
Use this command to display information about scheduled device resets.
Syntax
show reset
Parameters
None.
Defaults
None.
Mode
Switch command, Read‐Only.
Example
This command shows how to display reset information
Matrix(rw)->show reset
Reset scheduled for Fri Jan 21 2000, 23:00:00 (in 3 days 12 hours 56 minutes 57
seconds).
Reset reason: Software upgrade
2-94 Startup and General Configuration
show reset
Refer to page...
2-94
2-95
2-96
2-96
2-97