Disconnect - Enterasys Matrix DFE-Gold Series Configuration Manual

disconnect

Example
This example shows how to tell all users about a system reset:
Matrix(rw)->tell all system reset scheduled for 1 p.m. today
disconnect
Use this command to close an active console port or Telnet session from the switch CLI.
Syntax
disconnect {ip-addr | console}
Parameters
ip‐addr
console
Defaults
None.
Mode
Switch command, Read‐Write.
Examples
This example shows how to close a Telnet session to host 134.141.192.119:
Matrix(rw)->disconnect 134.141.192.119
This example shows how to close the current console session:
Matrix(rw)->disconnect console
Specifies the IP address of the Telnet session to be disconnected. This
address is displayed in the output shown in "show users" on page 11‐6.
Closes an active console port.
Enterasys Matrix DFE-Gold Series Configuration Guide 11-7
Monitoring Network Events and Status