Clear Rmon History; Set Rmon History - Enterasys Matrix DFE-Gold Series Configuration Manual

set rmon history

Sample 2304
Drop Events
Octets
Packets
Broadcast Pkts
Multicast Pkts
CRC Align Errors
set rmon history
Use this command to configure an RMON history entry.
Syntax
set rmon history index [port-string] [buckets buckets] [interval interval] [owner
owner]
Parameters
index
port‐string
buckets buckets
interval interval
owner owner
Defaults
• If buckets is not specified, the maximum number of entries maintained will be 50.
• If not specified, interval will be set to 30 seconds.
• If owner is not specified, monitor will be applied.
Mode
Switch command, Read‐Write.
Example
This example shows how configure RMON history entry 1 on port fe.2.1 to sample every 30
seconds:
Matrix(rw)->set rmon history 1 fe.2.1 interval 20

clear rmon history

Use this command to delete one or more RMON history entries or reset one or more entries to
default values. For specific values, refer to "set rmon history" on page 11‐19.
Syntax
clear rmon history {index-list | to-defaults}
Interval Start: 0 days 19 hours 11 minutes 35 seconds
= 0
= 0
= 0
= 0
= 0
= 0
Specifies an index number for this entry.
(Optional) Assigns this entry to a specific port.
(Optional) Specifies the maximum number of entries to maintain.
(Optional) Specifies the sampling interval in seconds.
(Optional) Specifies an owner for this entry.
Undersize Pkts
Oversize Pkts
Fragments
Jabbers
Collisions
Utilization(%)
Enterasys Matrix DFE-Gold Series Configuration Guide 11-19
Configuring RMON
= 0
= 0
= 0
= 0
= 0
= 0