Clear Ip Nat Translation; Clear Ip Nat Translation Inside (Nat) - Enterasys Matrix DFE-Gold Series Configuration Manual

Configuring Network Address Translation (NAT)
access-list 35 refcount 28
pool vlan 3000: netmask 0.0.0.0
start 85.1.1.1
type napt, total addresses 1, allocated 1, max_ports 32000, used_ports 28 (0%)
,
misses 0

clear ip nat translation

Use this command to clear active dynamic NAT translations.
Syntax
clear ip nat translation
Parameters
None.
Defaults
None.
Mode
Router command, Global configuration: Matrix‐>Router(config)#
Example
This example clears dynamic ip NAT translations for this router:
Matrix->Router(config)#clear ip nat translation

clear ip nat translation inside (NAT)

Use this command to clear an active simple NAT translation.
Syntax
clear ip nat translation inside global-ip local-ip
Parameters
global‐ip
local‐ip
Defaults
None.
Mode
Router command, Global configuration: Matrix‐>Router(config)#
18-12 Network Address Translation (NAT) Configuration
end 85.1.1.1
Specifies the unique public IP address to clear for this static simple
translation.
Specifies the private IP address to clear for this static simple translation.
clear ip nat translation