Show Lacp Flowregeneration; Set Lacp Flowregeneration - Enterasys Matrix DFE-Gold Series Configuration Manual

show lacp flowRegeneration

Mode
Switch command, Read‐Write.
Example
This example shows how to clear all link aggregation parameters for port ge.3.16:
Matrix(rw)->clear port lacp port ge.3.16
show lacp flowRegeneration
Use this command to display the LACP flow regeneration state.
Syntax
show lacp flowRegeneration
Parameters
None.
Defaults
None.
Mode
Switch command, Read‐Only.
Example
This example shows how to display the current LACP flow regeneration state:
Matrix(rw)->show lacp flowRegeneration
disable

set lacp flowRegeneration

Use this command to enable or disable LACP flow regeneration.
Syntax
set lacp flowRegeneration {enable | disable}
Parameters
enable | disable
Defaults
None.
Mode
Switch command, Read‐Write.
Enables or disables LACP flow regeneration
Enterasys Matrix DFE-Gold Series Configuration Guide 4-69
Configuring LACP