set spantree maxhops
set spantree maxhops
Use this command to set the Spanning Tree maximum hop count.
Syntax
set spantree maxhops max_hop_count
Parameters
max_hop_count
Defaults
None.
Mode
Switch command, Read‐Write.
Usage
Spanning Tree maximum hop count is the maximum number of hops that the information for a
particular Spanning Tree instance may traverse (via relay of BPDUs within the applicable MST
region) before being discarded.
Example
This example shows how to set the maximum hop count to 40:
Matrix(rw)->set spantree maxhops 40
clear spantree maxhops
Use this command to reset the maximum hop count to the default value of 20.
Syntax
clear spantree maxhops
Parameters
None.
Defaults
None.
Mode
Switch command, Read‐Write.
Example
This example shows how to reset the maximum hop count to 20:
Matrix(rw)->clear spantree maxhops
Specifies the maximum number of hops allowed. Valid values are 0 to
255. Default value is 20.
Enterasys Matrix DFE-Gold Series Configuration Guide 6-35
Configuring Spanning Tree Bridge Parameters