Clear Nodealias Config - Enterasys Matrix DFE-Gold Series Configuration Manual

Configuring Node Aliases
Parameters
port‐string port‐string
alias‐id alias‐id
Defaults
None.
Mode
Switch command, Read‐Write.
Example
This example shows how to clear all node alias entries on fe.1.3:
Matrix(rw)->clear nodealias port-string fe.1.3

clear nodealias config

Use this command to reset node alias state to enabled and clear the maximum entries value.
Syntax
clear nodealias config port-string
Parameters
port‐string
Defaults
None.
Mode
Switch command, Read‐Write.
Example
This example shows how to reset the node alias configuration on fe.1.3:
Matrix(rw)->clear nodealias config fe.1.3
14-8 Node Alias Configuration
Specifies the port(s) on which to remove all node alias entries. For a
detailed description of possible port‐string values, refer to "Port String
Syntax Used in the CLI" on page 4‐2.
Specifies the ID of the node alias to remove. This value can be viewed
using the show nodealias command as described in "show nodealias"
on page 14‐1.
Specifies the port(s) on which to reset the node alias configuration. For a
detailed description of possible port‐string values, refer to "Port String
Syntax Used in the CLI" on page 4‐2.
clear nodealias config