Show Ip Arp Output Details - Enterasys Matrix DFE-Gold Series Configuration Manual

Reviewing and Configuring the ARP Table
Table 16-3 show ip arp Output Details
Output...
Protocol
Address
Age (min)
Hardware Addr
Type
Interface
arp
Use this command to add or remove permanent (static) ARP table entries.
Syntax
arp ip-address mac-address arpa
no arp ip-address
Parameters
ip‐address
mac‐address
arpa
Defaults
None.
Mode
Router command, Global configuration: Matrix>Router(config)#
Usage
Up to 1,000 static ARP entries are supported per Enterasys Matrix Series routing module or
standalone device. A multicast MAC address can be used in a static ARP entry.
The "no" form of this command removes the specified permanent ARP entry.
Example
This example shows how to add a permanent ARP entry for the IP address 130.2.3.1 and MAC
address 0003.4712.7a99:
Matrix>Router(config)#arp 130.2.3.1 0003.4712.7a99 arpa
16-14 IP Configuration
What it displays...
ARP entry's type of network address.
Network address mapped to the entry's MAC address.
Interval (in minutes) since the entry was entered in the table.
MAC address mapped to the entry's network address.
Encapsulation type used for the entry's network address.
Interface (VLAN or loopback) through which the entry was learned.
Specifies the IP address of a device on the network. Valid values are IP
addresses in dotted decimal notation.
Specifies the 48‐bit hardware address corresponding to the ip‐address
expressed in hexadecimal notation.
Specifies ARPA as the type of ARP mapping.
arp