Configuring Spanning Tree Loop Protect Features
Example
This example shows how to reset the Loop Protect event window to the default of 180 seconds:
Matrix(rw)->clear spantree lpwindow
set spantree lptrapenable
Use this command to enable or disable Loop Protect event notification.
Syntax
set spantree lptrapenable {enable | disable}
Parameters
enable | disable
Defaults
None.
Mode
Switch command, Read‐Write.
Usage
Loop Protect traps are sent when a Loop Protect event occurs, that is, when a port goes to listening
due to not receiving BPDUs. The trap indicates port, SID and loop protection status.
Example
This example shows how to enable sending of Loop Protect traps:
Matrix(rw)->set spantree lptrapenable enable
show spantree lptrapenable
Use this command to display the current status of Loop Protect event notification.
Syntax
show spantree lptrapenable
Parameters
None.
Defaults
None.
Mode
Switch command, Read‐Only.
6-74 Spanning Tree Configuration
Enables or disables the sending of Loop Protect traps. Default is
disabled.
set spantree lptrapenable
Need help?
Do you have a question about the Enterasys Matrix DFE-Gold Series and is the answer not in the manual?