Clear Rmon Event - Enterasys Matrix DFE-Gold Series Configuration Manual

Configuring RMON
Parameters
index
enable
Defaults
None.
Mode
Switch command, Read‐Write.
Usage
An RMON event entry can be created using this command, configured using the set rmon event
properties command ("set rmon event properties" on page 11‐25), then enabled using this
command. An RMON event entry can be created and configured at the same time by specifying an
unused index with the set properties command.
Example
This example shows how to enable RMON event entry 1:
Matrix(rw)->set rmon event status 1 enable

clear rmon event

Use this command to delete an RMON event entry and any associated log entries.
Syntax
clear rmon event index
Parameters
index
Defaults
None.
Mode
Switch command, Read‐Write.
Example
This example shows how to clear RMON event 1:
Matrix(rw)->clear rmon event 1
11-26 Network Monitoring Configuration
Specifies an index number for this entry. Maximum number of entries is
100. Maximum value is 65535.
Enables this event entry.
Specifies the index number of the entry to be cleared.
clear rmon event