Show Multiauth Session-Timeout - Enterasys Matrix DFE-Gold Series Configuration Manual

Configuring Multiple Authentication
Defaults
If no authentication type is specified, the idle timeout value is returned to 300 seconds for all
authentication types.
Mode
Switch command, Read‐Write.
Examples
This example shows how to clear the idle‐timeout session values for cep and mac authentication
types, back to default value of 300 seconds:
Matrix(rw)->clear multiauth idle-timeout cep
Matrix(rw)->clear multiauth idle-timeout mac
This example shows how to clear the idle‐timeout session values for all authentication types, back
to the default value of 300 seconds:
Matrix(rw)->set multiauth idle-timeout

show multiauth session-timeout

Use this command to display session‐timeout values, in seconds, for all authentication methods.
Syntax
show multiauth session-timeout
Parameters
None
Defaults
None.
Mode
Switch command, Read‐Only.
Example
This example shows how to display multiple authentication session‐timeout values, for an active
session:
Matrix(rw)->show multiauth session-timeout
Authentication type
------------------- -------------
dot1x
pwa
mac
cep
27-12 MultiAuth Configuration
Timeout (sec)
0
0
0
0
show multiauth session-timeout