Set Igmp Config - Enterasys Matrix DFE-Gold Series Configuration Manual

set igmp config

Table 9-1 show igmp config Output Details (continued)
Output...
Vlan IGMP Version
VlanQuerier
VlanQueryMaxResponse
Time
VlanRobustness
VlanLastMemberQueryIntvl
VlanQuerierUpTime
set igmp config
Use this command to configure IGMP settings on one or more VLANs.
Syntax
set igmp config vlan-list {[query-interval query-interval] [igmp-version igmp-
version] [max-resp-time max-resp-time] [robustness robustness] [last-mem-int
last-mem-int]}
Parameters
vlan‐list
query‐interval query‐
interval
igmp‐version igmp‐
version
max‐resp‐time max‐
resp‐time
robustness robustness
last‐mem‐int last‐
mem‐int
Defaults
At least one optional parameter must be specified.
Mode
Switch command, Read‐Write.
What it displays...
Whether or not IGMP version is 1 or 2.
IP address of the IGMP querier.
Maximum query response time (in tenths of a second).
Robustness value.
Last member query interval. This is the maximum response time
inserted into group-specific queries which are sent in response to
Leave Group messages. It is also the amount of time between group-
specific query messages.
Time (in seconds) the IGMP querier has been active.
Specifies the VLAN(s) on which to configure IGMP.
(Optional) Specifies the frequency of host‐query frame transmissions.
Valid values are from 1 to 65535 seconds. This value works together
with max‐resp‐time to remove ports from an IGMP group.
(Optional) Specifies the IGMP version. Valid values are:
• 1 ‐ IGMP V1
• 2 ‐ IGMP V2
(Optional) Specifies the maximum query response time. Valid values
are 1 to 25 seconds. This value works together with query‐interval to
remove ports from an IGMP group.
(Optional) Specifies the robustness value. This can be increased to tune
for expected packet loss on a subnet. Valid values are 2 to 255.
(Optional) Specifies the Last Member Query Interval. This is the
maximum response time inserted into group‐specific queries which are
sent in response to Leave Group messages. It is also the amount of time
between group‐specific query messages. Valid values are 1 to 255.
Enterasys Matrix DFE-Gold Series Configuration Guide 9-9
Configuring IGMP