Set Spantree Autoedge; Clear Spantree Autoedge - Enterasys Matrix DFE-Gold Series Configuration Manual

set spantree autoedge

Example
This example shows how to display the status of the automatic edge port detection function:
Matrix(rw)->show spantree autoedge
autoEdge is currently enabled.
set spantree autoedge
Use this command to enable or disable the automatic edge port detection function.
Syntax
set spantree autoedge {disable | enable}
Parameters
disable | enable
Defaults
None.
Mode
Switch command, Read‐Write.
Example
This example shows how to disable automatic edge port detection:
Matrix(rw)->set spantree autoedge disable

clear spantree autoedge

Use this command to reset automatic edge port detection to the default state of enabled.
Syntax
clear spantree autoedge
Parameters
None.
Defaults
None.
Mode
Switch command, Read‐Write.
Example
This example shows how to reset automatic edge port detection to enabled:
Matrix(rw)->clear spantree autoedge
Disables or enables automatic edge port detection.
Enterasys Matrix DFE-Gold Series Configuration Guide 6-29
Configuring Spanning Tree Bridge Parameters