Ospf Configuration Task List And Commands - Enterasys Matrix DFE-Gold Series Configuration Manual

redistribute

OSPF Configuration Task List and Commands

Table 21‐2 lists the tasks and commands associated with OSPF configuration. Commands are
described in the associated section as shown.
Table 21-2 OSPF Configuration Task List and Commands .
To do this...
If necessary, activate your advanced routing
license.
Enable OSPF configuration mode, associate a
network and assign a router ID.
Configure OSPF Interface Parameters.
Set the cost of sending a packet on an OSPF
interface.
Set a priority to help determine the OSPF
designated router for the network.
Adjust timers and message intervals.
Configure OSPF authentication.
Configure OSPF Areas.
Configure an administrative distance.
Define the range of addresses to be used by
Area Boundary Routers (ABRs).
Enable area authentication.
Define an area as a stub area.
Set the cost value for the default route that is
sent into a stub area.
Define an area as an NSSA.
Create virtual links.
Note: Activating your advanced routing license, and enabling OSPF with the router ospf and
network commands are required if you want to run OSPF on the device. All other tasks are
optional.
Use these commands...
set license ("set license" on page 2-58)
router ospf ("router ospf" on page 21-22)
network ("network" on page 21-23)
router id ("router id" on page 21-24)
ip ospf cost ("ip ospf cost" on page 21-24)
ip ospf priority ("ip ospf priority" on page 21-25)
timers spf ("timers spf" on page 21-26)
ip ospf retransmit-interval ("ip ospf
page 21-26)
ip ospf transmit-delay ("ip ospf
page 21-27)
ip ospf hello-interval ("ip ospf
page 21-28)
ip ospf dead-interval ("ip ospf
page 21-28)
ip ospf authentication-key
page 21-29)
ip ospf message digest key md5
key md5" on page 21-30)
distance ospf ("distance ospf" on page 21-30)
area range ("area range" on page 21-31)
area authentication ("area
area stub ("area stub" on page 21-33)
area default cost ("area default
area nssa ("area nssa" on page 21-34)
area virtual-link ("area virtual-link" on page 21-35)
Enterasys Matrix DFE-Gold Series Configuration Guide 21-21
Configuring OSPF
retransmit-interval" on
transmit-delay" on
hello-interval" on
dead-interval" on
("ip ospf authentication-key" on
("ip ospf message digest
authentication" on page 21-32)
cost" on page 21-34)