Set Length; Show Logout - Enterasys Matrix DFE-Gold Series Configuration Manual

Setting Basic Device Properties

set length

Use this command to set the number of lines the CLI will display.
Syntax
set length screenlength
Parameters
screenlength
Defaults
None.
Mode
Switch command, Read‐Write.
Example
This example shows how to set the terminal length to 50:
Matrix(rw)->set length 50

show logout

Use this command to display the time (in seconds) an idle console or Telnet CLI session will
remain connected before timing out.
Syntax
show logout
Parameters
None.
Defaults
None.
Mode
Switch command, Read‐Only.
Example
This example shows how to display the CLI logout setting:
Matrix(rw)->show logout
Logout currently set to: 10 minutes.
2-52 Startup and General Configuration
Sets the number of lines in the CLI display. Valid values are 0, which
disables the scrolling screen feature described in "Displaying Scrolling
Screens" on page 2‐10, and from 5 to 512.
set length