Show Lldp Port Status; Show Lldp Port Trap - Enterasys Matrix DFE-Gold Series Configuration Manual

Link Layer Discovery Protocol and LLDP-MED

show lldp port status

Use this command to display the LLDP status of one or more ports.
Syntax
show lldp port status [port-string]
Parameters
port-string
Defaults
If port‐string is not specified, LLDP status information will be displayed for all ports.
Mode
Switch command, Read‐Only.
Usage
The command lists the ports that are enabled to send and receive LLDPPDUs. Ports are enabled or
disabled with the set lldp port status command.
Example
This example shows how to display LLDP port status information for all ports.
Matrix(ro)->show lldp port status
Tx-Enabled Ports
Rx-Enabled Ports

show lldp port trap

Use this command to display the ports that are enabled to send an LLDP notification when a
remote system change has been detected or an LLDP‐MED notification when a change in the
topology has been sensed.
Syntax
show lldp port trap [port-string]
Parameters
port-string
Defaults
If port‐string is not specified, LLDP port trap information will be displayed for all ports.
3-18 Discovery Protocols Configuration
(Optional) Displays LLDP status for one or a range of ports.
: ge.1.1-60; ge.2.1-24; ge.3.1-30; ge.4.1-12; ge.5.1-12;
tg.6.1-2; fe.7.1-48
: ge.1.1-60; ge.2.1-24; ge.3.1-30; ge.4.1-12; ge.5.1-12;
tg.6.1-2; fe.7.1-48
(Optional) Displays the port or range of ports that have been enabled to
send LLDP and/or LLDP‐MED notifications.
show lldp port status