Debug Ip Packet Restart - Enterasys Matrix DFE-Gold Series Configuration Manual

debug ip packet restart

Mode
Router command, Router configuration: Matrix>Router(config)#
Router Exec: Matrix>Router#
Usage
• Too high a throttle or limit value may require a second CLI session for CLI access due to the
volume of potential data.
• Use the debug ip packet restart command to restart the utility when the display limit has
been reached.
• Before entering this command, enter a set logging here enable command at the Read‐Write
command prompt to direct SYSLOG messages to this session.
• The current state of IP debugging is not displayed by the show running‐config command. It is
not a persistently saved configuration. To see the state of this command use the show
debugging command.
Example
This example shows how to set debug IP packet for throttle 5 and limit 20 with a detail value of
verbose:
Matrix(rw)->set logging here enable
Opened (71) at index 5
Matrix(rw)->router
Matrix(rw)->Router>enable
Matrix(rw)->Router#configure
Matrix(rw)->Router(config)#access-list 1 permit any
Matrix(rw)->Router(config)#debug ip packet access-group 1 throttle 5 limit 20
verbose
<165>Jun 26 13:53:03 65.41.41.41 DbgIpPkt[1.tDispEvent][2][Snd]Rule hit[1: permit
any] out vlan 2730
<165>Jun 26 13:53:04 65.41.41.41 DbgIpPkt[2.tDispEvent][1][Rcv]Rule hit[1: permit
any] PortSting empty for port-21 vlan 2730
<165>Jun 26 13:53:04 65.41.41.41 DbgIpPkt[2.tDispEvent][2][Rcv]Rule hit[1: permit
any] PortSting empty for port-21 vlan 2730
<165>Jun 26 13:53:05 65.41.41.41 DbgIpPkt[3.tDispEvent][1][Rcv]Rule hit[1: permit
any] PortSting empty for port-69 vlan 2730
.
.
.
Matrix(rw)->Router(config)#show debug
IP Packet debugging is on, with access-group 1 throttle 5 limit 20 verbose
Matrix(rw)->Router(config)#
debug ip packet restart
Use this command to restart the debug IP packet utility.
Syntax
debug ip packet restart
Enterasys Matrix DFE-Gold Series Configuration Guide 16-31
Configuring Debug IP Packet