Show Spantree Mstcfgid; Set Spantree Mstcfgid - Enterasys Matrix DFE-Gold Series Configuration Manual

show spantree mstcfgid

Example
This example shows how to display assignments for all VLANs assigned to any SID other than
SID 0:
Matrix(rw)->show spantree vlanlist
Vlan 104 is mapped to Sid 104
Vlan 105 is mapped to Sid 105
Vlan 106 is mapped to Sid 106
Vlan 107 is mapped to Sid 107
show spantree mstcfgid
Use this command to display the MST configuration identifier elements, including format selector,
configuration name, revision level, and configuration digest.
Syntax
show spantree mstcfgid
Parameters
None.
Defaults
None.
Mode
Switch command, Read‐Only.
Example
This example shows how to display the MST configuration identifier elements. In this case, the
default revision level of 0, and the default configuration name (a string representing the bridge
MAC address) have not been changed. For information on using the set spantree mstcfgid
command to change these settings, refer to "set spantree mstcfgid" on page 6‐17:
Matrix(rw)->show spantree mstcfgid
MST Configuration Identifier:
Format Selector: 0
Configuration Name: 00:01:f4:89:51:94
Revision Level: 0
Configuration Digest: ac:36:17:7f:50:28:3c:d4:b8:38:21:d8:ab:26:de:62

set spantree mstcfgid

Use this command to set the MST configuration name and/or revision level.
Syntax
set spantree mstcfgid {cfgname name | rev level}
Configuring Spanning Tree Bridge Parameters
Enterasys Matrix DFE-Gold Series Configuration Guide 6-17