Enterasys Matrix DFE-Gold Series Configuration Manual page 115

clear port inlinepower
Testing SDRAM....
Loading Boot Image: 01.00.02...
Uncompressing Boot Image...
Press any key to enter System Image Loader menu
2. Before the boot up completes, press any key. The following boot menu options screen
displays.
Options available
1
2
3
4
5
6
7
8
9
10 - Restore Configuration to factory defaults (delete config files)
3. Type 2. The following baud rate selection screen displays:
1 - 1200
2 - 2400
3 - 4800
4 - 9600
5 - 19200
6 - 38400
7 - 57600
8 - 115200
0 - no change
4. Type 8 to set the device baud rate to 115200. The following message displays:
Setting baud rate to 115200, you must change your terminal baud rate.
5. Set the terminal baud rate to 115200 and press ENTER.
6. Type download to start the ZMODEM receive process.
7. Send the image file using the ZMODEM protocol from your terminal application. (This
procedure will vary depending on your application.) When the ZMODEM download is
finished, the following message displays:
[System Image Loader]: download
Preparing to receive file...
Writing file...
Download successful.
[System Image Loader]:
8. Set the device baud rate back to 9600.
- Start operational code
- Change baud rate
- Retrieve event log using XMODEM (64KB).
- Load new operational code using XMODEM
- Display operational code vital product data
- Run Flash Diagnostics
- Update Boot Code
- Delete operational code
- Reset the system
Reviewing and Selecting a Boot Firmware Image
PASSED.
DONE.
DONE.
Enterasys Matrix DFE-Gold Series Configuration Guide 2-73