Cli "Defaults" Descriptions; Cli Command Modes - Enterasys Matrix DFE-Gold Series Configuration Manual

Startup and General Configuration Summary
Table 2-2 Default Device Settings for Router Mode Operation (continued)
Device Feature
OSPF priority
Passive interfaces (RIP)
Proxy ARP
Receive interfaces (RIP)
Retransmit delay (OSPF)
Retransmit interval (OSPF) Set to 5 seconds.
RIP receive version
RIP send version
RIP offset
SNMP
Split horizon
Stub area (OSPF)
Telnet
Telnet port (IP)
Timers (OSPF)
Transmit delay (OSPF)
VRRP

CLI "Defaults" Descriptions

Each command description in this guide includes a section entitled "Defaults" which contains
different information than the factory default settings on the device as described in Table
Table 2‐2. The command defaults section defines CLI behavior if the user enters a command
without typing optional parameters (indicated by square brackets [ ]). For commands without
optional parameters, the defaults section lists "None". For commands with optional parameters,
this section describes how the CLI responds if the user opts to enter only the keywords of the
command syntax.

CLI Command Modes

Each command description in this guide includes a section entitled "Command Mode" which
states whether the command is executable in Admin (Super User), Read‐Write or Read‐Only
mode. Users with Read‐Only access will only be permitted to view Read‐Only (show) commands.
Users with Read‐Write access will be able to modify all modifiable parameters in set and show
commands, as well as view Read‐Only commands. Administrators or Super Users will be allowed
all Read‐Write and Read‐Only privileges, and will be able to modify local user accounts. The
Matrix Series device indicates which mode a user is logged in as by displaying one of the
following prompts:
• Admin: Matrix(su)‐>
• Read‐Write: Matrix(rw)‐>
• Read‐Only: Matrix(ro)‐>
2-6 Startup and General Configuration
Default Setting
Set to 1.
None configured.
Enabled on all interfaces.
Enabled on all interfaces.
Set to 1 second.
Set to accept both version 1 and version 2.
Set to version 1.
No value applied.
Enabled.
Enabled for RIP packets without poison reverse.
None configured.
Enabled.
Set to port number 23.
SPF delay set to 5 seconds. SPF holdtime set to 10 seconds.
Set to 1 second.
Disabled.
2‐1 and