Show Ip Interface; Show Ip Interface Output Details - Enterasys Matrix DFE-Gold Series Configuration Manual

show ip interface

show ip interface
Use this command to display information, including administrative status, IP address, MTU
(Maximum Transmission Unit) size and bandwidth, and ACL configurations, for interfaces
configured for IP.
Syntax
show ip interface [vlan vlan-id | loopback loopback-id | lo loopback-id]
Parameters
vlan vlan‐id |
loopback loopback‐id
lo loopback‐id
Defaults
If interface type is not specified, status information for all routing interfaces will be displayed.
Mode
Router command, Any router mode.
Example
This example shows how to display configuration information for VLAN 1: Matrix>Router#show
ip interface vlan 1
Vlan 1 is Oper DOWN
Frame Type ARPA
MAC-Address 0001.f4da.2cba
Incoming Access List is not Set
Outgoing Access List is not Set
IP Helper Address is not Set
MTU is 1500 bytes
ARP Timeout is 14400 seconds
Proxy Arp is Enabled
Gratuitous arp learning is not set
ICMP Re-Directs are enabled
ICMP Unreachables are always sent
ICMP Mask Replies are always sent
Policy routing disabled
Table 16‐2 provides an explanation of the command output.
Table 16-2 show ip interface Output Details
Output...
Vlan | Lpbk | Lo N
IP Address
Frame Type
(Optional) Displays information for a specific VLAN, loopback, or local
interface. This interface must be configured for IP routing as described
in "Pre‐Routing Configuration Tasks" on page 2‐100.
What it displays...
Whether the interface is administratively and operationally up or down.
Interface's IP address and mask. Set using the ip address command
as described in "ip
Encapsulation type used by this interface. Set using the arp command
as described in "arp" on page 16-14.
Enterasys Matrix DFE-Gold Series Configuration Guide 16-5
Configuring Routing Interface Settings
address" on page 16-6.