Show Spantree Priority; Set Spantree Priority - Enterasys Matrix DFE-Gold Series Configuration Manual

Configuring Spanning Tree Bridge Parameters
Defaults
None.
Mode
Switch command, Read‐Write.
Example
This example shows how to reset the bridge priority mode to 802.1t:
Matrix(rw)->clear spantree bridgeprioritymode

show spantree priority

Use this command to display the Spanning Tree bridge priority.
Syntax
show spantree priority [sid]
Parameters
sid
Defaults
If sid is not specified, priority will be shown for Spanning Tree 0.
Mode
Switch command, Read‐Only.
Example
This example shows how to show the bridge priority for Spanning Tree 0
Matrix(rw)->show spantree priority
Bridge Priority is set to 4096 on sid 0

set spantree priority

Use this command to set the device's Spanning Tree priority.
Syntax
set spantree priority priority [sid]
6-20 Spanning Tree Configuration
(Optional) Displays the priority for a specific Spanning Tree. Valid
values are 0 ‐ 4094. If not specified, SID 0 is assumed.
show spantree priority