Clear Port Priority-Queue - Enterasys Matrix DFE-Gold Series Configuration Manual

clear port priority-queue

Parameters
port‐string
priority
queue
Defaults
None.
Mode
Read‐Write.
Usage
This command enables you to change the priority queue (0‐7, depending on port type, with 0
being the lowest priority queue) for each port priority of the selected port. You can apply the new
settings to one or more ports. For example, if the priority queue is set to 3 for those frames with a
port priority 4, then those frames would be transmitted before any frames contained in traffic
classes 2 through 0.
Example
This example shows how to set priority 5 frames received on fe.2.12 to transmit at the lowest
priority queue of 0.
Matrix(rw)->set port priority-queue fe.2.12 5 0
clear port priority-queue
Use this command to reset port priority queue settings back to defaults for one or more ports.
Syntax
clear port priority-queue port-string
Parameters
port‐string
Defaults
None.
Specifies the port(s) for which to set priority queue. For a detailed
description of possible port‐string values, refer to "Port String Syntax
Used in the CLI" on page 4‐2.
Specifies a value of 0 ‐ 7(0 is the lowest level) that determines what
priority frames will be transmitted at the priority queue level entered in
this command.
Specifies a value (0 is the lowest level) that determines when to transmit
the frames with the port priority entered in this command. Number of
transmit queues varies by port type. Typical values are:
• 100Base‐T ‐ 4
• 1000Base‐T ‐ 4
• 1000Base‐X ‐ 8
Specifies the port for which to clear priority queue. For a detailed
description of possible port‐string values, refer to "Port String Syntax
Used in the CLI" on page 4‐2.
Enterasys Matrix DFE-Gold Series Configuration Guide 22-7
Configuring Priority to Transmit Queue Mapping