Set Maclock Enable; Set Maclock Disable - Enterasys Matrix DFE-Gold Series Configuration Manual

set maclock enable

Table 24-2 show maclock stations Output Details
Output...
Status
State
set maclock enable
Use this command to enable MAC locking on one or more ports.
Syntax
set maclock enable [port_string]
Parameters
port_string
Defaults
If port_string is not specified, MAC locking will be enabled on all ports.
Mode
Switch command, Read‐Write.
Usage
MAC locking is disabled by default at device startup. Configuring one or more ports for MAC
locking requires globally enabling it on the device and then enabling it on the desired ports as
described in "set maclock" on page 24‐6.
When enabled and configured for a specific MAC address and port string, this locks a port so that
only designated end station addresses are allowed to participate in frame relay.
Example
This example shows how to enable MAC locking on fe.2.3:
Matrix(rw)->set maclock enable fe.2.3

set maclock disable

Use this command to disable MAC locking on one or more ports.
Syntax
set maclock disable [port_string]
What it displays...
Whether the end stations are active or inactive.
Whether the end station locked to the port is a first learned, first
arrival or static connection.
(Optional) Enables MAC locking on specific port(s). For a detailed
description of possible port_string values, refer to "Port String Syntax
Used in the CLI" on page 4‐2.
Enterasys Matrix DFE-Gold Series Configuration Guide 24-5
Configuring MAC Locking