Set Rmon Filter - Enterasys Matrix DFE-Gold Series Configuration Manual

Configuring RMON
Parameters
index index | channel
channel
Defaults
If no options are specified, information for all filter entries will be displayed.
Mode
Switch command, Read‐Only.
Example
This example shows how to display all RMON filter entries and channel information:
Matrix(rw)->show rmon filter
Index= 55508
----------------------------------------------------------
Data Offset
PktStatusMask
Owner
-----------------------------
Data
ff ff ff ff ff ff
-----------------------------
DataMask
ff ff ff ff ff ff
-----------------------------
DataNotMask
00 00 00 00 00 00

set rmon filter

Use this command to configure an RMON filter entry.
Syntax
set rmon filter index channel_index [offset offset] [status status] [smask smask]
[snotmask snotmask] [data data] [dmask dmask] [dnotmask dnotmask] [owner owner]
Parameters
index
channel_index
offset offset
status status
11-38 Network Monitoring Configuration
(Optional) Displays information about a specific filter entry, or about all
filters which belong to a specific channel.
Channel Index= 628
0 PktStatus
0 PktStatusNotMask
ETS,NAC-D
Specifies an index number for this entry. An entry will automatically be
created if an unused index number is chosen. Maximum number of
entries is 10. Maximum value is 65535.
Specifies the channel to which this filter will be applied.
(Optional) Specifies an offset from the beginning of the packet to look
for matches.
(Optional) Specifies packet status bits that are to be matched.
EntryStatus= valid
0
0
set rmon filter