Show Spantree Txholdcount; Set Spantree Txholdcount - Enterasys Matrix DFE-Gold Series Configuration Manual

show spantree txholdcount

Example
This example shows how to clear topology change trap suppression settings:
Matrix(rw)->clear spantree tctrapsuppress
show spantree txholdcount
Use this command to display the maximum BPDU transmission rate.
Syntax
show spantree txholdcount
Parameters
None.
Defaults
None.
Mode
Switch command, Read‐Only.
Example
This example shows how to display the transmit hold count setting:
Matrix(rw)->show spantree txholdcount
Tx hold count = 3.

set spantree txholdcount

Use this command to set the maximum BPDU transmission rate.
Syntax
set spantree txholdcount txholdcount
Parameters
txholdcount
Defaults
None.
Mode
Switch command, Read‐Write.
Usage
Maximum BPDU transmission rate is the number of BPDUs which will be transmitted before
transmissions are subject to a one‐second timer.
Specifies the maximum number of BPDUs to be transmitted before
transmissions are subject to a one‐second timer. Valid values are 1 ‐ 10.
Default value is 6.
Enterasys Matrix DFE-Gold Series Configuration Guide 6-33
Configuring Spanning Tree Bridge Parameters