Show Rmon Matrix Output Details - Enterasys Matrix DFE-Gold Series Configuration Manual

show rmon matrix
Parameters
port‐string
source | dest
Defaults
• If port‐string is not specified, information about all ports will be displayed.
• If not specified, information about source and destination addresses will be displayed.
Mode
Switch command, Read‐Only.
Example
This example shows how to display RMON matrix properties and statistics. A control entry
displays first, followed by actual entries corresponding to the control entry:
Matrix(rw)->show rmon matrix
------------------
Matrix Index
Interface
Table size
Last deletion
Status
Owner
Source
Packets
Errors
Table 11‐7 provides an explanation of the command output. Properties are set using the set rmon
matrix properties command as described in "set rmon matrix properties" on page 11‐34.
Table 11-7 show rmon matrix Output Details
Output...
Matrix Index
Interface
Table size
Last deletion
Status
Owner
Source
Destination
Packets
(Optional) Displays RMON properties and statistics for a specific
port(s).
(Optional) Sorts the display by source or destination address.
1
32009
100
116647
1
monitor
00-e0-63-9d-c1-c8
= 2
= ---
What it displays...
Index number for this RMON matrix entry.
Interface for which host monitoring is being conducted.
Number of entries in the matrix table for this interface.
System up time when the last entry was deleted from the matrix table
associated with this entry.
Whether this matrix entry is enabled (valid) or disabled.
Text string identifying who configured this entry.
Source of the data from which this entry creates a traffic matrix.
Destination of the data from which this entry creates a traffic matrix.
Number of packets (including bad packets) transmitted from the source
address to the destination address.
Destination 00-a0-c9-03-cd-7c
Octets = 286
Enterasys Matrix DFE-Gold Series Configuration Guide 11-33
Configuring RMON