Ip Pim Rp-Candidate - Juniper JUNOSE SOFTWARE 11.2.X - XML MANAGEMENT PROTOCOL GUIDE 6-30-2010 Command Reference Manual

JunosE 11.2.x Command Reference Guide A to M

ip pim rp-candidate

Syntax
Release Information
Description
Options
Mode
898
ip pim rp-candidate interfaceType interfaceSpecifier [ group-list accessListName ]
[ hold-time holdTime ] [ priority priority ] [ interval interval ]
no ip pim rp-candidate interfaceType interfaceSpecifier
Command introduced before JunosE Release 7.1.0.
Defines a router as a rendezvous point (RP) router candidate. The no version stops the
router from being an RP candidate.
interfaceType—Interface type; see Interface Types and Specifiers on page 5
interfaceSpecifier—Particular interface; format varies according to interface type; see
"Interface Types and Specifiers" on page 5. The autoRP announcement messages
will contain the IP address for this interface.
accessListName—Access list containing the set of group prefixes supported by this
C-RP. If no group-list is specified, the default value is the entire multicast address
range.
holdTime—Amount of time in the range 1–65535 seconds that the BSR keeps an RP
in its C-RP list if the BSR does not receive a C-RP advertisement message; default
value is 150 seconds
priority—Priority field value in the range 0–255 that the C-RP sends to the BSR in C-RP
advertisement messages. In the RP election process, the RP with the lower priority
value is preferred; default value is 192
interval—Interval in the range 1–65535 seconds at which the C-RP sends advertisement
messages to the BSR; default value is 60 seconds
Global Configuration
Copyright © 2010, Juniper Networks, Inc.