Table of Contents
Advertisement
This chapter describes how to configure discovery protocols. For more extensive configuration
information, refer to the "Configuring Neighbor Discovery" feature guide on the Enterasys
Networks web site: http://www.enterasys.com/support/manuals
For information about...
Configuring CDP
Configuring Cisco Discovery Protocol
Configuring Link Layer Discovery Protocol and LLDP-MED
Configuring CDP
Purpose
To review and configure the Enterasys CDP discovery protocol. This protocol is used to discover
network topology. When enabled, this protocol allows Enterasys devices to send periodic PDUs
about themselves to neighboring devices.
Commands
The commands used to review and configure the CDP discovery protocol are listed below.
For information about...
show cdp
set cdp state
set cdp auth
set cdp interval
set cdp hold-time
clear cdp
show neighbors
Discovery Protocol Configuration
Refer to page...
6-1
6-7
6-13
Refer to page...
6-2
6-3
6-4
6-4
6-5
6-5
6-6
SecureStack C3 Configuration Guide 6-1
6
- Quick Links:
- Set Ip Address
Hide quick links:
Advertisement
Table of Contents
Need help?
Do you have a question about the SECURESTACK C3 and is the answer not in the manual?
Questions and answers