Set Lldp Trap-Interval - Enterasys SecureStack B3 Configuration Manual

set lldp trap-interval

B3(rw)->set lldp hold-multiplier 5
set lldp trap-interval
Use this command to set the minimum interval between LLDP notifications sent by this device.
LLDP notifications are sent when a remote system change has been detected.
Syntax
set lldp trap-interval frequency
Parameters
frequency
Defaults
None.
Mode
Switch command, read‐write.
Example
This example sets the minimum interval between LLDP traps to 10 seconds.
B3(rw)->set lldp trap-interval 10
4-24 Discovery Protocol Configuration
Specifies the minimum time between LLDP trap transmissions, in
seconds. The value can range from 5 to 3600 seconds. The default
value is 5 seconds.