Clear Radius - Enterasys SECURESTACK C3 Configuration Manual

This example shows how to set the RADIUS timeout to 5 seconds:
C3(su)->set radius timeout 5
This example shows how to set RADIUS retries to 10:
C3(su)->set radius retries 10
This example shows how to force any management‐access to the switch (Telnet, web, SSH) to
authenticate through a RADIUS server. The all parameter at the end of the command means that
any of the defined RADIUS servers can be used for this Authentication.
C3(rw)->set radius realm management-access all

clear radius

Use this command to clear RADIUS server settings.
Syntax
clear radius [retries] | [timeout] | [server {index | all | realm {index | all}}]
Parameters
retries
timeout
server
index | all
realm
Mode
Switch command, read‐write.
Defaults
None.
Examples
This example shows how to clear all settings on all RADIUS servers:
C3(su)->clear radius server all
This example shows how to reset the RADIUS timeout to the default value of 20 seconds:
C3(su)->clear radius timeout
Resets the maximum number of attempts a user can contact the RADIUS
server before timing out to 3.
Resets the maximum amount of time to establish contact with the RADIUS
server before timing out to 20 seconds.
Deletes server settings.
For use with the server parameter to clear the server configuration for all
servers or a specific RADIUS server as defined by an index.
Resets the realm setting for all servers or a specific RADIUS server as
defined by an index.
SecureStack C3 Configuration Guide 26-9
clear radius