Set System Login; Clear System Login - Enterasys SECURESTACK C3 Configuration Manual

set system login

set system login
Use this command to create a new user login account, or to disable or enable an existing account.
The SecureStack C3 switch supports up to 16 user accounts, including the admin account, which
cannot be deleted.
Syntax
set system login username {super-user | read-write | read-only} {enable | disable}
Parameters
username
super‐user |
read‐write |
read‐only
enable | disable
Defaults
None.
Mode
Switch command, super user.
Usage
Login accounts, including the admin user account, can be locked out after multiple failed attempts
to log in to the system. Refer to "show system lockout" on page 3‐7 and "set system lockout" on
page 3‐8 for more information about lockout parameters.
If the admin user account has been locked out, you must wait until the configured lockout time
period has expired or you can power cycle the switch to reboot it, which will re‐enable the admin
user account.
Example
This example shows how to enable a new user account with the login name "netops" with super
user access privileges:
C3(su)->set system login netops super-user enable

clear system login

Use this command to remove a local login user account.
Syntax
clear system login username
3-4 Basic Configuration
Specifies a login name for a new or existing user. This string can be a
maximum of 80 characters, although a maximum of 16 characters is
recommended for proper viewing in the show system login display.
Specifies the access privileges for this user.
Enables or disables the user account.