Set Arp - Enterasys Matrix 2G4072-52 Configuration Manual

Logging And Network Management Command Set
Managing Switch Network Addresses and Routes
11.2.5.2

set arp

Use this command to add mapping entries to the switch's ARP table.
set arp ip-address mac-address [{temp | pub | trail}]
Syntax Description
ip-address
mac-address
temp
pub
trail
Command Defaults
•
•
•
Command Type
Switch command.
Command Mode
Read-Write.
Example
This example shows how to map IP address 198.133.219.232 to MAC address 00-00-0c-40-0f-bc:
Matrix(rw)->
11-100 Matrix DFE-Platinum and Diamond Series Configuration Guide
Specifies the IP address to map to the MAC address and
add to the ARP table.
Specifies the MAC address to map to the IP address and
add to the ARP table.
(Optional) Sets the ARP entry as not permanent. This
allows the entry to time out.
(Optional) Publishes the specified ARP entry. This causes
the system to respond to ARP requests for this entry, even
though it is not the host.
(Optional) Specifies that trailer encapsulations can be sent
to this host.
If temp is not specified, the ARP entry will be added as a permanent entry.
If pub is not specified, then the ARP entry will not be published.
If trail is not specified, then trailer encapsulations will not be sent to the host.
set arp 198.133.219.232 00-00-0c-40-0f-bc