Show Spantree Lp - Enterasys Matrix 2G4072-52 Configuration Manual

Spanning Tree Configuration Command Set
Configuring Spanning Tree Loop Protect Features
6.2.3.2

show spantree lp

Use this command to display the Loop Protect status per port and/or per SID.
show spantree lp [port port-string] [sid sid]
Syntax Description
port-string
sid sid
Command Defaults
If no port-string is specified, status is displayed for all ports.
If no SID is specified, SID 0 is assumed.
Command Type
Switch command.
Command Mode
Read-Only.
Example
This example shows how to display Loop Protect status on fe.2.3:
Matrix(rw)->show spantree lp port fe.2.3
LoopProtect is enabled on port fe.2.3
6-122 Matrix DFE-Platinum and Diamond Series Configuration Guide
(Optional) Specifies port(s) for which to display the Loop
Protect feature status. For a detailed description of possible
port-string values, refer to
(Optional) Specifies the specific Spanning Tree(s) for
which to display the Loop Protect feature status. Valid
values are 0 - 4094. If not specified, SID 0 is assumed.
Section 4.1.1.
, SID 0