Set Lldp Port Status; Set Lldp Port Trap - Enterasys SECURESTACK C3 Configuration Manual

set lldp port status

set lldp port status
Use this command to enable or disable transmitting and processing received LLDPDUs on a port
or range of ports.
Syntax
set lldp port status {tx-enable | rx-enable | both | disable} port-string
Parameters
tx‐enable
rx‐enable
both
disable
port‐string
Defaults
None.
Mode
Switch command, read‐write.
Example
This example enables both transmitting LLDPDUs and receiving and processing LLDPDUs from
remote systems on ports ge.1.1 through ge.1.6.
C3(rw)->set lldp port status both ge.1.1-6

set lldp port trap

Use this command to enable or disable sending LLDP notifications (traps) when a remote system
change is detected.
Syntax
set lldp port trap {enable | disable} port-string
Parameters
enable
disable
port‐string
Defaults
None.
6-26 Discovery Protocol Configuration
Enables transmitting LLDPDUs on the specified ports.
Enables receiving and processing LLDPDUs from remote systems on
the specified ports.
Enables both transmitting and processing received LLDPDUs on the
specified ports.
Disables both transmitting and processing received LLDPDUs on the
specified ports.
Specifies the port or range of ports to be affected.
Enable transmitting LLDP traps on the specified ports.
Disable transmitting LLDP traps on the specified ports.
Specifies the port or range of ports to be affected.