Set Lldp Med-Fast-Repeat; Set Lldp Port Status - Enterasys SecureStack C2 Configuration Manual

set lldp med-fast-repeat

set lldp med-fast-repeat
Network connectivity devices transmit only LLDP TLVs in LLDPDUs until they detect that an
LLDP‐MED endpoint device has connected to a port. At that point, the network connectivity
device starts sending LLDP‐MED TLVs at a fast start rate on that port. Use this command to set the
number of successive LLDPDUs (with LLDP‐MED TLVs) to be sent for one complete fast start
interval.
Syntax
set lldp med-fast-repeat count
Parameters
count
Defaults
None.
Mode
Switch command, read‐write.
Example
This example sets the number of fast start LLDPDUs to be sent to 4.
C2(rw)->set lldp med-fast-repeat 4

set lldp port status

Use this command to enable or disable transmitting and processing received LLDPDUs on a port
or range of ports.
Syntax
set lldp port status {tx-enable | rx-enable | both | disable} port-string
Parameters
tx‐enable
rx‐enable
both
disable
port‐string
Defaults
None.
4-24 Discovery Protocol Configuration
Specifies the number of fast start LLDPDUs to be sent when an
LLDP‐MED endpoint device is detected. Value can range from 1 to
10. Default is 3.
Enables transmitting LLDPDUs on the specified ports.
Enables receiving and processing LLDPDUs from remote systems on
the specified ports.
Enables both transmitting and processing received LLDPDUs on the
specified ports.
Disables both transmitting and processing received LLDPDUs on the
specified ports.
Specifies the port or range of ports to be affected.