Table of Contents
Advertisement
Configuring Power over Ethernet (PoE)
This section applies only to PoE-equipped SecureStack B3 devices. Consult the Installation Guide shipped
with your product to determine if it is PoE-equipped.
Purpose
To review and set PoE parameters, including the power available to the system, the usage
threshold for each module, whether or not SNMP trap messages will be sent when power status
changes, and per‐port PoE settings.
Commands
The commands used to review and set PoE port parameters are listed below.
For information about...
show inlinepower
set inlinepower threshold
set inlinepower trap
show port inlinepower
set port inlinepower
show inlinepower
Use this command to display switch PoE properties.
Syntax
show inlinepower
Parameters
None.
Defaults
None.
Mode
Switch command, read‐only.
Important Notice
Configuring Power over Ethernet (PoE)
Refer to page...
3-31
3-32
3-32
3-33
3-33
SecureStack B3 Configuration Guide 3-31
Advertisement
Table of Contents
